Electronics Forum | Thu Dec 21 13:11:25 EST 2006 | SWAG
We have fought with cut-tape way too much. It's always a bad idea. We've tried a couple methods/devices for manual splice with limited success. Before you look into this I would ask them if they could supply you cut tape qty's inslusive of fairly
Electronics Forum | Mon Oct 08 14:50:30 EDT 2012 | dscott
This would be a good place to start http://www.vtekusa.com/
Electronics Forum | Tue Jan 05 07:48:39 EST 2021 | mbass
Go for Gen 2 NT feeders, the Gen 1 Feeders tend to be problematic the older they get whereas the Gen 2 feeders are a much better prospect. I've used 8, 12, 16, 24 and 44mm. Some problems to look out for is pull back of coverlay and removal of waste
Electronics Forum | Mon May 15 13:55:00 EDT 2000 | Aldo
We are in the process of researching manual or low cost automatic Tape and Reel equipment. I have heard about V-tek and Systemation. I would appreciate if someone can tell me any problems or virtues of theses two brands that have been experienced. Al
Electronics Forum | Wed Aug 22 14:25:22 EDT 2007 | russ
Go inform the owner of your company that you are spending hours of labor dealing with these parts instead of spending the extra 4 dollars it takes to buy an entire reel. When we deal with strips we make sure that an extra amount is ordered to apply
Electronics Forum | Thu Mar 13 09:43:13 EDT 2008 | jseagle
If the mask is not cured and is coming off in the pot I don't see how it is protecting anything. If you want to mask something fast you need to use tape not liquid mask that requires cure. My $.02.
Electronics Forum | Thu Dec 03 07:49:30 EST 1998 | Steve Sauer
Hi Scott, The only information that I have on the Intelliplace machine is that it is their own design unlike the other models (Casio) that they are licensed to sell. As for the other machine (Europlacer Progress 6), I have an extensive background wit
Electronics Forum | Thu Oct 14 18:17:34 EDT 1999 | JAX
Larry, What's happening. You can get this information from the manufacturer. All you need is the manufacturing part number. You should be able to get this from the purchasing department. Once you have this info just open up their website and fo
Electronics Forum | Thu Dec 21 08:31:32 EST 2006 | Karkanov
Hi, Do you have any idea if there is some tool to inspecet if we have the right component on the board ? like a smart tweezer. Also I'm looking to find a tool to spice smt reel. I need that because our buyer told us they will only buy cut tape.
